OIL FILLER TUBE (UPPER) REPLACEMENT (Sheet 3 of 4)
Position plate (A) on cap assembly (B).
Place two flat washers (C) on two drive screws
Using hammer, carefully tap two drive screws
through holes in plate (A) into cap assembly (B).
Press new packing (E) under lip of cap assembly
Position cap assembly (B) on tube assembly (F).
Using screwdriver, install two screws (G).
Place tube assembly (F) in vise, place rounded
end of spring (H) in notch of cap assembly (B)
and, using screwdriver, work end of spring in
notch of tube assembly (F).
G0 on to Sheet 4