Electrical Panel and BII Compartment
and Tool and Battery Compartment
Electrical panel and BII compartment (1) is the left
compartment at the rear of the machine. To gain
access to the electrical panel and BII compartment, lift
the bottom of rubber latches (4), and then rotate the
top of the rubber latches away from the compartment.
Use grab rail (3) to pull the lid towards the rear of the
machine, and then raise the lid.
Close electrical panel and BII compartment (1) by
lowering the lid, rotating the top of rubber latches (4)
towards the compartment, and then pushing the
bottom of the rubber latches towards the
compartment. The lid is secure when the top of the
rubber latch clamps the lip which is attached to the
Tool and battery compartment (2) is the right
compartment, at the rear of the machine. Two rubber
latches (5) secure the lid of the compartment. Access
to the tool battery compartment can be gained by
following the same procedure as described for access
to electrical panel and BII compartment (1).
Emergency Brake Release Valve
NOTE: The emergency brake release valve is used by
Unit Maintenance personnel when they tow the
Radiator Shown in Raised Position for Photographic Clarity.
Valve (1) is located on the multifunction valve in the air
intake compartment, on the left side of the machine.
OpenTurn valve (1) fully counterclockwise for normal
ClosedTurn valve (1) fully clockwise to prepare the
machine for manual parking brake release. When valve
(1) is closed, the drain passage from the parking brake
is plugged, which allows the manual brake release
pump to operate.