TM 9-2350-222-20-1-4
PARKING BRAKE CONTROL ASSEMBLY REPLACEMENT (ENGINE COMPARTMENT)
(Sheet 15 of 15)
41.
Position bracket (AQ) on transmission stud.
Install washer (AR) and nut (AS) to secure bracket (AQ). Using 3/4 inch socket, tighten nut.
42.
Using 3/4 inch socket and torque wrench, tighten nut (AS) to 55-60 lb-ft (74-81 N-m).
43.
Install clamp (AT) on control assembly,
44.
Install screw (AU), new lockwasher (AV), and nut (AW) to secure clamp (AT) to bracket (AQ)
45.
Using 7/16 inch wrench to hold nut (AW) and 7/16 inch socket on screw (AU), tighten screw (AU).
Adjust clamp (AT) to allow clearance between control assembly and transmission oil filler tube
46.
bracket.
Install clamp (AX) on control assembly
47.
Install new lockwasher (AY) and nut (AZ) to secure clamp.
48.
49.
Using 3/4 inch socket and extension, tighten nut (AZ).
Using 3/4 inch socket and torque wrench, tighten nut (AZ) to 55-60 lb-ft (74-81 N.m).
50.
Adjust clamp to maintain minimum 3/4 inch clearance between control assembly and
51.
turbocharger.
52.
53.
Install 2A powerplant (page 5-14) or 2D powerplant (page 5-37).
End of Task
TA140404
13-98