TM 9-2350-222-20-1-4
PARKING BRAKE CONTROL ASSEMBLY REPLACEMENT (ENGINE COMPARTMENT)
(Sheet 9 of 16)
3.
Position control assembly to transmission. Place end with nut installed at brake housing,
4.
Position control assembly end rod through hole in brake housing.
5.
Deleted.
6.
As you are inserting control assembly end rod, install the following parts in the following order:
new packing with new retainer (D), nut (C), washer (E), spring (F), and washer (G).
7.
Continue inserting control assembly and guide end of rod through brake lever (H) and install one nut
(J) onto rod end. It may be necessary to compress spring (F) to permit rod end to pass through brake
lever (H).
TA253443
13-92
Change 1