TM 9-2350-222 -20-1-4
SHIFTING CONTROL ROD AND LEVERS REPLACEMENT (Sheet 2 of 4)
3.
Using 9/16 inch wrench, remove bolt (D) from lever (E) and rod end (F) and separate rod end from
clevis of lever (E).
4.
Using 7/16 inch wrench, remove screw (G) and nut (H) from lever (E).
5.
Using 9/16 inch wrench, hold screw (J). Using other 9/16 inch wrench, remove nut (K) and
lockwasher (L) from screw (J). Remove screw (J) and lever (E) from transmission shaft. It may be
necessary to use hammer and screwdriver to remove lever (E). Throw lockwasher away.
6.
Using 9/16 inch wrench on flats of rod end (F) and 9/16 inch wrench on jam nut (M), loosen
jamnut (M) and remove rod end (F) from rod (N).
7.
Using 9/16 inch wrench, remove jamnut (M) from rod (N).
8.
Using 9/16 inch wrench, remove bolt (P) from lever (Q).
9.
Using 9/16 inch wrench on flats of rod end (R) and 9/16 inch wrench on jamnut (S), loosen jam nut
(S) and remove rod end (R) from rod (N).
Using 9/16 inch wrench, remove jamnut (S) from rod (N).
10.
11.
Using hammer and punch, drive spring pin (T) from lever (Q). Remove lever (Q) and throw pin (T)
away.
Go on to Sheet 3
TA139299
11-46