TM 9-2350-222-20-1-4
DUST DETECTOR WARNING LIGHT BOX ASSEMBLY AND BRACKET REPLACEMENT (Sheet 1 of 3)
TOOLS:
Pliers, slip joint, plastic jaw insert
Screwdriver, cross tip
3/8 in. combination box and open end wrench
7/16 in. combination box and open end wrench (2 required)
SUPPLIES:
Lockwasher (MS35333-40) (6 required)
Lockwasher (MS35338-42) (4 required)
REMOVAL:
1.
Using pliers, disconnect harness connector
(A) from dust detector warning light box (B).
2. Using one 7/16 inch wrench to hold nuts (C),
use other 7/16 inch wrench to remove two
Remove box (B). Throw Iockwashers away.
NOTE
If the dust detector warning light box in your vehicle
has the NATO slave connector type mounting, do
step 3 and skip step 4. If you have the conventional
slave connector type mounting, skip step 3 and do
step 4.
Using screwdriver, remove four screws (F)
3.
and Iockwashers (G) securing bracket (H) to
NATO slave connector mount (J). Remove
TA250691
Go on to Sheet 2
10-350.16
Change 3