REPLACEMENT OF HULL INTERMEDIATE LEAD ASSEMBLY (Sheet 2 of 4)
U s i n g slip joint pliers, unthread retaining
nut (C) from shell (D). Slide retaining nut
(C) back along cable.
Slide sleeving (E) back along lead assembly (F)
Slide bushing (G) back along cable.
Remove pin (H) from position "C" of insert (J)
pull lead assembly (F) back through bushing (G) and retaining nut (C).
Using diagonal cutting pliers, cut tie downs securing lead assembly (F) to harness bundle
end working back toward driver's compartment, pull lead assembly (F) from beneath
At dust detector warning light box (K) in
driver's compartment, disconnect lead
assembly connector (L) from short lead
(M) on dust detector warning light wiring
Remove hull intermediate lead assembly
(F) from vehicle.
Go on to Sheet 3