TM 9-2350-222-20-14
ENGINE WIRING HARNESS REPLACEMENT (2D ENGINE) (Sheet 11 of 12)
36.
Place wiring harness (A) in position.
37.
Place clamp (AU) and clamp (AV), which is
hidden, in position around wiring harness (A).
38.
Using 1/2 inch socket with extension, install
two clamps (AU) and (AV).
39.
Using slip joint pliers, install connector (AX) to
ignition unit (AY).
40. Using 1/2 inch socket with extension, install
screw and new lockwasher (AZ) securing ground
strap (BA) to engine.
41. Place clamp (BB) in position arouns\d wiring
harness (A).
42. Using 1/2 inch socket with extension, install
screw and new lockwasher (BC) securing clamp
(BB).
Using 1 inch wrench, connect connector (BD)
Position connector (BF) in bracket (BG).
Using cross-tip screwdriver and adjustable
wrench, install four screws, new Iockwashers,
and nuts (BH).
Using spanner wrench, install connector (BJ).
Go on to Sheet 12
TA139900
10-349