TM 9-2350-222-20-1-4
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR
FEMALE PLUG REPAIR (Sheet 1 of 3)
TOOLS: Electrical connector repair tool kit
Slip joint pliers with plastic jaw inserts
Diagonal cutting pliers
SUPPLIES: Silicone compound (Item 32, Appendix D)
Electrical tape (Item 58, Appendix D)
Jumper wire
PRELIMINARY PROCEDURES:
Loosen or remove cable clamps as required
Disconnect connectors at each end of affected cable
1. Manually thread grommet retaining nut (A)
from plug assembly (B).
2. Slide grommet retaining nut (A) back along
cable (C).
3. Using slip joint pliers, work grommet (D)
back and forth and out of plug assembly (B).
4. Using remover, push contact (E) with
damaged wire out of back of plug assembly
(B).
Using diagonal cutting pliers, cut wire from contact (E). Throw away contact (E).
Go on to Sheet 2
TA139869
10-318