TM 9-2350-222-20-1-4
MASTER RELAY REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
Traverse turret to expose master relay. Position master relay (A) into plate (B).
1.
Using socket, install two bolts (C), four new lockwashers (D), and two nuts (E) to hold master
2.
relay (A) to bracket (F).
NOTE
If your vehicle has protection device (G), continue with steps 3
through 7. If your vehicle does not have protection device (G),
skip step 3 and continue with steps 4 through 7.
Using 3/4 inch wrench, install protection device (G) to master relay (A).
3.
Using 7/8 inch wrench, install connector (H).
4.
5.
Using spanner wrench, install connector (J) to master relay (A).
6.
Using spanner wrench, install connector (K) to master relay (A).
7.
Connect three battery ground cable assemblies to battery terminals (page 10-285).
End of Task
TA139724
10-168