TM 9-2350-222-20-1-4
MASTER CONTROL PANEL REPAIR (Sheet 41 of 65)
Master Heater Circuit Breaker, Hi-Lo Switch, and Indicator Light
Replacement (Sheet 5 of 7)
INSTALLATION:
1.
Place indicator light (A) in position on rear of
panel.
2.
Using 3/4 inch socket, install nut (B) securing
indicator light (A) to panel.
3.
Using cross-tip screwdriver, install and secure
(E) to panel.
4.
Using flat-tip screwdriver, remove screws and
washers from terminals 2 through 6 of
replacement hi-lo switch (F). Retain screws and
washers for installation.
5.
Position electrical leads and jumper wire (G) to
switch (F) as shown,
NOTE
Electrical leads (circuits 407
and 405) are part of indicator
light (A).
6.
Using flat-tip screwdriver, secure leads to
terminals with screws and washers removed in
step 4.
GO on to Sheet 6
TA139651
10-95