TM 9-2350-222-34-1
TRANSMISSION REPLACEMENT (Sheet 1 of 24
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Cleaning
Installation
TOOLS: 1/2 in. combination box and open end
5/8 in. socket with 1/2 in. drive
wrench (2 required)
3/4 in. socket with 1/2 in. drive
9/16 in. combination box and open end
Universal joint with 1/2 in. drive
wrench
5 in. extension with 1/2 in. drive
3/4 in. combination box and open end
1-1/8 in. socket with 3/4 in. drive
wrench
Ratchet with 3/4 in. drive
7/8 in. combination box and open end
torque wrench with 3/4 in. drive (0-600 lb-
wrench
ft) (0-813 N-m)
15/16 in. combination box and open end
Flat-tip screwdriver
wrench
Slip joint pliers
5/8 in. combination box and open end
Hose clamp pliers
wrench
Snap ring pliers
1-1/2 in. open end wrench
Ratchet with 1/2 in. drive
1-5/8 in. open end wrench
Putty knife
1/2 in. socket with 1/2 in. drive
Pry bar
9/16 in. socket with 1/2 in. drive
Transmission sling (7081593)
Puller attachment (7082201)
SPECIAL TOOLS: Mechanical puller adapter (Item 2, Chapter 2, Section I)
Pinion turning wrench (Item 5, Chapter 2, Section I)
FABRICATED TOOLS: Wrench (Item 1, Appendix D)
SUPPLIES: Gaskets (10864007) (2 required)
Gloves (Item 13.1, Appendix B)
Cotter pins (2 required)
Goggles (Item 13.2, Appendix B)
Preformed packing (7723892)
Gasket (7767860)
Dry cleaning solvent (Item 12,
Drain pan
Rags (Item 31, Appendix B)
Wooden blocks 10 x 10 x 12 in. (2
required)
ID tags
Gasket (8357269) (2 required)
Gaskets (7707806) (2 required)
Metallic gaskets (MS35769-31) (4
required)
PERSONNEL: Two
REFERENCES: TM 9-2350-222-20-1
LO 9-2350-222-12
PRELIMINARY PROCEDURES: Remove powerplant (TM 9-2350-222-20-1)
Remove engine shroud and supports (TM 9-2350-222-20-1)
Go on to Sheet 2 Remove right angle drive, clutch and pump (TM 9-2350-222-20-1)
Change 3 6-22
