TM 9-2350-222-34-1
STARTER FEED HARNESS ASSEMBLY REPLACEMENT (2D ENGINE) (Sheet 2 of 5)
NOTE
Strap type clamps should be left in
place by removing only one screw. If
replacement of strap is required,
remove both screws.
3. Remove starter feed harness (C) from bulkhead.
4. Using wrench, remove screw (D), lockwasher (E),
and flat washer (F) from strap (G).
5. Using wrench, remove screw (H) and lockwasher (J).
6. Remove clamp (K).
7. From engine compartment, using wrench, remove
from two covers (P).
Go on to Sheet 3
TA130656
5-77