TM 9-2350-222-34-1
FUEL PRIMER PUMP REPAIR (Sheet 5 of 6)
ASSEMBLY:
1. Using 9/16 inch wrench, install two inlet valves
and new preformed packings (A) and two
outlet valves and new preformed packings (B)
in primer pump (C).
securing inlet and outlet valves (A and B).
3. Install rod assembly (E) in primer pump (C).
4. Using 1-1/2 inch wrench, install and tighten
gland (F) of rod assembly (E) into primer pump
(C).
thru holes (G) securing rod assembly (E) to
primer pump (C).
6. Install lower sleeve (H) on switch assembly (J).
7. Place plunger (K) over switch assembly (J).
8. Place flat end of upper sleeve (L) over switch
assembly (J).
9. Place handle (M) over assemblies (H, J, K, L) and
aline holes in handle (M) and lower sleeve (H).
10. Using screwdriver, install screw (N) and lockwasher
(P).
Go on to Sheet 6
TA130549
4-90