TM 9-2350-222-20-2-3-2
M240 MACHINE GUN MOUNT ASSEMBLY PROCEDURE (CONT)
35-9.
PROCEDURE
STEP
1.
Put roller (1) in trigger actuator lever (2), line up holes and slide in roller pin (3).
2.
Using hammer and punch, attach roller pin (3) to trigger actuator lever (2) with two spring roll pins
(4).
Using hammer and punch, attach linkage shaft (5) to trigger actuator lever (2) with spring roll pin (6).
3.
Put trigger linkage shaft (5) with attachments in gun mount (7) and slide on manual trigger (8).
4.
NOTE
Spring roll pin (6) is only partially installed to aid in machine gun
mount adjustment (para 35-10).
5.
Using hammer, put spring roll pin (6) about half-way through manual trigger (8) and trigger linkage
shaft (5).
NOTE
If solenoid clevis (9) was removed, do step 6, otherwise go to
step 7.
Screw solenoid clevis (9) in solenoid (10).
6.
7.
Put solenoid (10) on gun mount (7).
Using 7/16 inch wrench, attach solenoid (10) to gun mount (7) with three screws (11).
8.
9.
Using needle nose pliers, lockwire three screws (11) (JPG).
NOTE
Spring roll pin (12) is only partially installed to aid in machine gun mount
adjustment (para 35-10).
Using hammer, put spring roll pin (12) about half-way through solenoid clevis (9) and manual
10.
trigger (8).
GO TO FRAME 4
Para 35-9 Cont
35-38 Change 1
