TM 9-2350-222-20-2-1
SECTION 2: ALIGNMENT AND ADJUSTMENT
ALIGNMENT AND ADJUSTMENT PROCEDURES INDEX
3-6.
Para
Page
Task
3-7
Synchronization Spindle Adjustment of 165-MM Gun
3-28.8
with Gunner's Periscope M32C/M32CE1
3-8
3-36
Parallax Adjustment of Gunner's Periscope
M32C/M32CEl
3-7.
SYNCHRONIZATION SPINDLE ADJUSTMENT OF 165-MM GUN WITH GUNNER'S
PERISCOPE M32C/M32CE1 (CONT)
NOTE
This procedue can be performed using the M32C or
M32CE1 periscope. Whenever the M32C is mentioned it
will also be in reference to the M32CE1.
TEST EQUIPMENT: Gunner's Quadrant M1A1
Diagonal cutting pliers
TOOLS:
Spanner wrench
15/16 in. combination wrench
7/16 in. combination wrench
0.050 in. socket head screw key (Allen wrench)
1/2 in. socket (3/8 in. drive)
3/8 in. drive ratchet
SUPPLY: Lead seal wire
PERSONNEL: Two
TM 9-2350-222-10 for procedures to:
REFERENCES:
Manually traverse turret and elevate/depress 165-mm gun
ETM 643-091-940R/JPG for procedure to replace lead seal wire
TM 9-1290-200-14&P for procedure to calibrate and use Gunner's Quadrant M1A1
Initial setup for synchronization of 165-mm gun with gunner's periscope
EQUIPMENT CONDITION:
M32C (para 3-4, frames 1 through 10)
This procedure is done when the 165-mm gun is out of synchronization
GENERAL INSTRUCTIONS:
with gunner's periscope M32C by the tolerances specified in para 3-4,
frames 8 and 9.
Para 3-6
(3-28.7 blank)/3-28.8
Change 1
