TM 9-2350-222-20-1-4
ROADWHEEL ARM REPLACEMENT (Sheet 6 of 7)
1.
Remove covering from roadwheel support
housing opening.
2.
Apply a light coat of grease to outer edge of
new inner grease seal.
3.
Position inner grease seal (A) into roadwheel
housing (B) opening so BACK of seal (A) goes in
towards hull. You should be able to see
FRONT of seal (A) as you look into housing.
4.
Using oil seal replacer and handle, tap
lightly on handle with hammer until inner
seal has bottomed in housing (B).
5.
Coat all parts on upper spindle (C) with grease.
6.
Install new gasket (D) to mounting face of
retainer (E).
NOTE
Upper spindle (C) must be properly
alined with support housing (B)
while roadwheel arm (F) is being
installed.
CAUTION
Do not use excessive force while
installing roadwheel arm; damage
to seal may result.
7.
Using two persons, install upper spindle (C)
completely into support housing (B).
Go on to Sheet 7
Change 5
14-7
