TM 9-2350-222-20-14
FINAL DRIVE VENTING SYSTEM REPLACEMENT (Sheet 8 of 10)
11. Using fingers, connect adapter (L) to tube assembly (H).
12. Install two clamps (M) on tube assembly (N) and position tube assembly to hull.
13. Using fingers, connect tube assembly (N) to adapter (L).
14. Using 13/ 16 inch wrench to hold adapter (L), and using torque wrench with 11/16 inch crowfoot,
tighten tube assembly (H) 75-85 lb-in (8.4-9.5 N" m). Using torque wrench with 9/16 inch
crowfoot, tighten tube assembly (N).
i
15. Using 7/16 inch wrench, install and tighten screws (P) and new lockwashers (Q) securing clamps (M)
to hull.
Go on to Sheet 9
Change 5 12-27