TM 9-2350-222-20-1-4
HEADLIGHT HARNESS BASE ASSEMBLY REPLACEMENT (Sheet 2 of 4)
Disconnect six electrical connectors (A) by pulling apart.
2.
3.
Using screwdriver, remove screw (D), Iockwasher (E), ground lead (F), and lockwasher (G) from hull.
Throw lockwashers away.
Outside of vehicle, using wrench, remove
three screws (H), lockwashers (J), and flat
washers (K) securing base assembly (L) to
tube assembly (M). Throw Iockwashers
away.
NOTE
Remove connectors and leads
one at a time.
Remove base assembly (L) and gasket (N).
Throw gasket away.
Go on sheet 3
10-248 Change 1
