TM 9-2350-222-20-1-4
8.
Using fingers, install two nuts (K) and flat
washers (L) on studs (M) securing cradle (N) to
cradle bracket (P).
position cradle assembly (Q) to generator (F)
9.
and engine.
10. Using 9/16 inch wrench, install three screws (R)
and flat washers (S) securing cradle assembly
(Q) to engine.
11. Using 9/16 inch wrench, install new lockwasher
(W), ground strap (V), flat washer (U), and
screw (T).
12. Using pliers, install two lockwires (X) (Item 60,
Appendix D).
13. Using 9/16 inch wrench, tighten nuts (K).
Go on to Sheet 12
TA139569
10-14