TM9-2360-222-20-1-3
ACCELERATOR CROSSOVER ROD ASSEMBLY REPLACEMENT (Sheet 5 of 6)
4.
Using retaining ring pliers, install retaining
ring (G) in left groove on lever rod (E).
5.
Slide bearing unit (C) on lever rod (E).
6.
Using retaining ring pliers, install retaining
ring (H) in right groove on lever rod (E).
Install woodruff key (J) on lever rod (E).
7.
Slide lever (K) on lever rod (E) until lever (K) is
8.
over woodruff key (J).
Using wrench, install two screws (L) and new
9.
lockwashers (M) in detent plate (F) and lever
(K).
NOTE
Make sure correct number of shims are under each hole.
Line up holes in hose clamp (N), bracket (P), cover (Q), bearing units (G), shims (R), spacers (S), and
10,
channel (T).
Using socket, install four screws (U) and new lockwashers (V).
11.
Go on to Sheet 6
TA149117
7-433
