TM9-2350-222-20-1-3
FUEL-WATER SEPARATOR OPERATIONAL TESTS (2D ENGINE) (Sheet 11 of 11)
Using 1/2 inch wrench, close bleed cap (S) until snug by turning clockwise.
19.
20.
Using adjustable wrench, remove pipe plug from upper sensor hole (A).
Using 1/2 inch wrench, install sensor retaining nut (T).
21.
NOTE
Upper sensor (F) is longer than lower sensor (G).
Using 1/2 inch wrench to hold sensor
22.
retaining nut (T), use 9/16 inch wrench to
install upper sensor (F) into fuel-water separa-
tor (D).
Using adjustable wrench, remove pipe plug
23.
from lower sensor hole (U).
Using 1/2 inch wrench, install sensor
24.
retaining nut (V).
25.
Using 1/2 inch wrench to hold sensor
retaining nut (V), use 9/16 inch wrench and
install lower sensor (G) inot fuel-water separa-
tor (D).
26.
Position clamp (W) onto fuel-water separator
and, using 1/2 inch socket, install three
(X).
27.
Using 1/2 inch socket, tighten capscrew (Y).
28.
End of Task
TA253238
7-276 Change 1