TM 9-2360-222-20-1-3
FUEL TANK (LEFT AND RIGHT) LEVEL GAGE TRANSMITTER REPLACEMENT
(Sheet 2 of 4)
NOTE
Steps 1, 2, and 3 only apply to
right fuel gage transmitter.
1.
Using 1/2 inch socket, remove three screws and
lockwashers (A) and one flat washer (B)
securing bracket (C), safety chain (D), and cover
(E) to fuel tank. Throw lockwashers away.
Using wrench to hold nut, use 7/16 inch socket to remove screw, lockwasher, washer, and nut (F)
2.
securing clamp to bracket (C). Throw lockwasher away.
3.
Remove bracket (C) and cover (E).
4.
Disconnect electrical lead (G) from transmitter
(H).
5.
Using pliers, cut and remove lockwire (J).
6.
Using screwdriver, remove five screws and
washers (K) securing transmitter (H) to fuel
tank.
7.
Carefully lift transmitter (H) out of fuel tank
until float arm gears (L) are visible in fuel tank
opening (M).
8.
Reach in with finger and pull upon visible tip
of float arm. Pull transmitter (H) out of fuel
tank opening (M) until float appears.
Go on to Sheet 3.
TA141 428
7-168
