TM9-2350-222-20-1-3
AIR CLEANER INTAKE AND HOSE REPLACEMENT (Sheet 2 of 5)
REMOVAL:
1.
Using wrench, loosen clamp nut (A) at end of intake hose (B).
2.
Slide clamp (C) over intake hose (B) to middle of hose.
3.
Using screwdriver, pry hose (B) from elbow (D) and remove clamp (C).
4.
Close grille doors and go inside turret.
5.
Traverse turret to gain access to air intake.
6.
Using 1/2 inch socket, remove four screws and
lockwashers (E). Throw lockwashers away.
7.
Remove cover and gasket (F),
8.
Inspect gasket cemented to cover (F), If
damaged, use putty knife and remove gasket.
Apply adhesive (Item 2, Appendix D) to new
gasket and position onto cover.
9.
Using 9/16 inch socket, remove eight nuts an
lockwashers (G). Throw lockwashers away.
10.
Remove air intake flange assembly (H) and
hose.
11.
Inspect gasket (J) cemented to bulkhead. If
damaged, use putty knife and remove gasket.
Apply adhesive (Item 2, Appendix D) to new
gasket (J) and position on bulkhead,
Go on to Sheet 3
7-83
