TM 5-5420-226-20- I
(
—
Symptom-31
DETAILED
TROUBLESHOOTING
PROCEDURE
VEHICLE
OPERATION
- HULL
POWER
o
STEP
26
CONTINUED
(Continued)
l Check if me{er indicates continuity.
Does meter indicate
continuity?
A
)
l Inspect bulkhead engine
disconnect
harness for bent/
broken connector
contacts
or
loose CKT 478 wire at rear of
connectors.
l Repair connectors if defective
(page 10-298).
l If connectors are not
defective,
notify
support
maintenance
of a defective
bulkhead
engine disconnect
harness.
l Connect front accessory
harness
connector
to voltage
regulator.
l Install floor access cover
(page 17-9).
l install front accessory
harness
connector
at
bulkhead
disconnect
(page 10-270).
)
l Inspect front accessory
harness for bent/broken
connector
contacts
or loose
CKT 478 wire at rear of
connectors.
l Repair connectors if defective
(page 10-298).
l If connectors are not
defective,
notify
support
maintenance
of a defective
front
accessory
harness.
l Connect front accessory
harness connector
to voltage
regulator.
l Install floor access cover
(page 17-9).
l Install front accessory
harness connector
at
bulkhead
disconnect
(page 10-270).
TA107O98
4-409
