( TM   5-5420-226-20-1 SvmtMom-28 DETAILED TROUBLESHOOTING PROCEDURE –.. & STEP 13 CONTINUED VEHICLE OPERATION -  HULL POWER (Continued) l  Check   if  meter   indicates   continuity. I Does   meter    indicate continuity? , l l l l l l l l l Inspect hull   power harness from battery to   master relay circuit breaker for    bent/ broken connector contacts or   loose    CKT   400-459   wire   at rear   of   connectors. Repair    connectors if defective (page    10-298). If  connectors are   not defective, notify support maintenance of   bad   hull power harness. . Connect hull   power harness connectors to   master relay circuit breaker. Install    floor access cover (page    17-9). Connect three    battery ground straps    (page    10-268). Install basket-control panel power harness connector at basket disconnect. Connect basket-control panel power harness connector to master control panel. Install master control panel (page    10-33). 1 CKT I J CONTACT I -1 ( -@- ) l  inspect   basket-control panel power harness    for   bent/ broken connector contacts or loose   CKT  400-459  wire   at  rear of   connectors. l  Repair   connectors   if  defective (page10-298). l  If  connectors    are   not defective, notify support maintenance of   bad   basket- control panel   power harness. l  Connect   hull   power   harness connectors to   master relay circuit breakers. l  Install   floor   access   cover (page    17-9). l  Install   basket-control panel power harness connector at basket disconnect. l  Connect   basket-control panel power harness connector to master control panel. l  Install    master   control   panel (page    10-33). l  Connect   three    battery ground straps (page    10-268). TA107O79 4-390