TM 5-2350-262-20-2
4-894.2 Change 3
WINCH ASSEMBLY REPLACEMENT
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP
Tools:
4910-00-754-0654 Shop Equipment,
Automotive Maintenance and Repair:
Organizational Maintenance, Common
No. 1, Less Power
5180-00-177-7033 Took Kit, General
Mechanic’s: Automotive
Lifting Device
Chain
Materials:
Caps and Plugs
Item 7
Appendix D
Sealing
Item 14
Compound
Appendix D
Drycleaning
Item 31
Solvent
Appendix D
Parts :
Cotter Pin (2)
Lockwasher (16)
Parts Reference:
TM 5-2350-262-24P
Group A5
Personnel Required:
Two Construction Equipment Repairers
62B10
Reference:
TM 5-2350-262-10
Troubleshooting Reference:
TM 5-2350-262-20-3
Winch Will Not
Pull Rated Load
Equipment Condition:
Condition
Reference
Description
TM 5-2350-262-10
Ejector Forward
Page 4-296
Ejector Cylinder
Bracket Removed
Page 4-355 and
Rear Floor Plates
4-360
and Supports
Removed
General Safety Instructions:
WARNING
•
Ejector cylinder weighs 325 lb (148 kg).
Support ejector cylinder with blocks or
straps while it is being moved. Do not put
hands or feet under ejector cylinder while it
is being moved.
•
Hot engine and engine components can
cause serious burns. Do not work in engine
compartment or on engine components until
engine is cool.
•
Ensure hydraulic pressure is relieved after
ejector is pushed forward. Pressure may
build up and cause the ejector to retract.
•
Always wear leather gloves when handing
wire rope. Never allow wire rope to run
through hands.
•
Drycleaning solvent is flammable and will
not be used near an open flame. A fire
extinguisher will be kept nearby when the
solvent is used. Use only in well-ventilated
areas.
•
Lifting device must have a weight capacity
greater than 550 lb (250 kg).
•
Personnel must stand clear during lifting
operations.
