TM 5-2350-262-20-2
4-869.1 Change 3
TRACK ADJUSTING CYLINDER REPLACEMENT
(NEW PRODUCTION)
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP
Tools:
4910-00-754-0654 Shop Equipment
Automotive Maintenance and Repair:
Organizational Maintenance, Common
No. 1, Less Power
5180-00-177-7033 Tool Kit, General
Mechanic’s: Automotive
Materials:
Caps and Plugs
Item 7
Appendix D
Grease
Item 19
Appendix D
Lubricating Oil
Item 26
Appendix D
Parts :
O-rings (2)
Locknuts (5)
Parts Reference:
TM 5-2350-262-24P
Group AM
TM 5-2350-262-20-1
Group AR
TM 5-2350-262-20-1
Group A3
Personnel Required:
Construction Equipment Repairer 62B10
Reference:
TM 5-2350-262-10
Troubleshooting References:
Page 3-171
Vehicle Throws
Track
TM 5-2350-262-20-3
Equipment Condition:
Condition
Reference
Description
• TM 5-2350-262-10
Track Tension
Relieved
• TM 5-2350-262-20-1 Hydraulic Pressure
Relieved
• Page 4-361
Rear Floor Plates
Removed
General Safety Instructions:
WARNING
•
High pressure is present in the M9
hydraulic system. Do not disconnect any
hydraulic system component unless
hydraulic system pressure has been
relieved. Ensure each of the hydraulic
control levers is moved several times
through all positions, and the hydraulic
tank dipstick is slowly loosened to relieve
pressure. Failure to comply ay result in
sever injury to personnel.
•
Spilled hydraulic oil is very slippery. Use
caution when entering or working in bowl
area. Wipe up any spilled oil immediately.
•
Do not operate ejector when personnel
are in bowl. Do not work in bowl unless
ejector lock is engaged. Failure to comply
may result in severe injury to personnel.
