TM 5-2350-262-10
2-56 Change 6
Do not work under vehicle unless hull
is blocked and apron lockpins are
installed. Failure to comply may result
in severe injury to personnel or death.
WARNING
FOLDING THE DOZER BLADE
Do not ejector when personnel are in
bowl. Do not work in bowl unless
ejector lock is engaged. Failure to
comply may result in severe injury to
personnel or death.
WARNING
1 Remove shovel (1) and chain (2) from
apron (3).
2 Start the engine (p 2-37) and allow it to
warm up ffor 3 to 5 minutes.
3 Place SPRUNG/UNSPRNG control lever
(4) in SPRUNG possition.
4 Move ejector stop (5) away from ejector
move control lever (6). and move ejector (7)
forward to within about 2 ft (61 cm) of
apron (3).
5 Push apron control lever (8) forward and
raise apron (3) to full open position.
Remove shovel and chain from
stowage location on apron to prevent
damage.
CAUTION
Do not step on ejector Hydraulic
cylinderrod when in bowl checking
compensating pumpfor damage or
leaks. Failure to comply may result in
scratching the polish cylinder rod seal
surface.
CAUTION
Do not staand or work under raised
apron assembly unless apron lock pins
are installed. Apron assembly can
drop. causing severe injury to
personnel or death.
WARNING
