TM 9-2350-222-34-1
HYDRAULIC PUMP DISCHARGE TUBES ASSEMBLY REPLACEMENT (Sheet 5 of 7)
NOTE
Steps 2 thru 8 are performed in crew
compartment.
2. Place new bulkhead seal (F) over tube (A) and
into bulkhead mount (G).
3. Install packing nut (H) onto tube (A) and, using
fingers, start nut (H) into bulkhead mount (G).
4. Using 1-1/4 inch wrench, tighten packing nut (H)
into bulkhead mount (G).
5. Position coupling nut (J) onto tube (A).
NOTE
Clinch sleeve fits tightly over tube. It
may be necessary to use block of
wood and hammer, tapping lightly, to
install onto tube.
6. Place clinch sleeve (K) onto tube (A). Bottom
tube (A) firmly in seat of clinch sleeve (K).
NOTE
Connect tubes (A) or (B) to hydraulic
pump discharge tubes only finger
tight, to allow for final alinement of
tubes (A) or (B) in vehicle.
7. Have two persons in engine compartment push
tube (A) forward to connect with adapter (L).
8. Using 1-5/8 inch wrench to hold adapter (L) and
1-1/2 inch wrench on nut (J), connect nut (J) to
adapter (L).
Go on to Sheet 6
TA130868
12-45