TM 9-2350-222-34-1
REAR STEERING CONTROL ROD REPLACEMENT (Sheet 1 of 3)
TOOLS:
Torque wrench with 1/2 in. drive (0-175 lb-ft) (0-237 N-m)
9/16 in. crowfoot wrench with 1/2 in. drive
9/16 in. combination box and open end wrench
5/8 in. combination box and open end wrench (2 required)
9/16 in. socket with 1/2 in. drive
REFERENCE
TM 9-2350-222-20-1
PRELIMINARY PROCEDURES:
Remove outer riser link shield at rear of vehicle (TM 9-2350-222-20-1)
2.
Using 9/16 inch wrench, remove self-locking bolt (B).
3.
Disconnect connector rod end (C) from link.
4.
Using 9/16 inch wrench, remove rod end (C) and jamnut (A).
5.
Pull shield (D) to rear. Pull it off rod (E) toward rear of vehicle.
6.
Using two 5/8 inch wrenches, one to hold front rod while loosening connecting rod at end connector, remove rear
steering control rod (E).
Go on to Sheet 2
TA252652
Change 1 10-16