TM 9-2350-222-34-1
ROADWHEEL ARM REPAIR (NUMBER 1 LEFT AND RIGHT) (Sheet 1 of 7)
PROCEDURE INDEX
PROCEDURE
PAGE
Disassembly
Assembly
TOOLS:
Hammer
Chisel
Arbor press-
Drive collar bushing 4 in. inside dia. 8 in. Ig.
Drive collar bushing 4-9/16 in. inside dia. 10 in. Ig.
Drive collar bushing 6 in. inside dia. 12 in. Ig.
Oxygen-acetylene torch
SPECIAL TOOLS:
Shock absorber bearing replacer (Item 9, Chapter 2 Section I)
Bearing tool assembly (Item 10 Chapter 2, Section 1)
SUPPLIES:
PRELIMINARY PROCEDURES:
Remove hub and bearings (TM 9-2350-222-20-1)
Remove roadwheel arm (TM 9 2350-222-20-1)
DISASSEMBLY:
NOTE
Roadwheel arm has two spindles,
one spindle end is tapered and is
referred to as the lower spindle. The
other spindle is not tapered and is
referred to as the upper spindle.
Go on to Sheet 2
Change 5 9-2