TM 9-2350-222-34-1
BRAKE MASTER CYUNDER REPAIR (Sheet 2 of 5)
2.
Using 1-1/8 inch wrench, remove filler cap (C)
and gasket (D) from cylinder (A).
3.
Using 3/8 inch wrench, remove bleeder valve
(E).
4.
Using 3/4 inch wrench, remove plug (F) and
gasket (G).
5.
Insert cross-tip screwdriver in cylinder (A) and
press in on piston (H) while removing retaining
ring (J) with flat-tip screwdriver.
6.
Insert flat-tip screwdriver through hole (K) and
push out washer (L), piston (H), rubber cup (M),
spring (N), and retainer (P).
7.
Remove retainer (P) from spring (N).
8.
Separate spring (Q) from retainer (P) by
pressing on valve (R) and turning.
9.
Insert screwdriver through hole (K) and remove
seat (S) from cylinder (A).
Go on to Sheet 3
TA130733
8-3