TM 9-2350-222-34-1
SHIFTING CONTROL ROD ASSEMBLY REPLACEMENT (Sheet 1 of 2)
TOOLS: 1-1/2 lb. hammer
9/16 in. crowfoot wrench with 1/2 in. drive
1/4 in. drive punch
Torque wrench with 1/2 in. drive
5/8 in. combination box and open end
(0-175 lb-ft) (0-237 N-m)
wrench
9/16 in. socket with 1/2 in. drive
9/16 in. combination box and open end
wrench (2 required)
SUPPLIES: Pin (MS9390-440) (2 required)
REFERENCE: TM 9-2350-222-20-1 Remove right fuel tank (page 4-36)
PRELIMINARY PROCEDURES:
REMOVAL:
1. Using hammer and punch, remove pin (A) from universal joint (B). Throw pin (A) away.
2. Using 9/16 inch wrench, remove screw (C) from rod end (D).
3. Pull rod end (D) from clevis (E).
4. Remove shaft (F) from rod (G).
5.
Using hammer and punch, remove pin (H) from universal joint (J). Throw pin (H) away.
6.
Remove shaft (F) from universal joint (J).
7.
Using 9/16 inch wrench to hold nut (K), use 9/16 inch wrench to remove rod end (D) from shaft (F).
8.
Using 9/16 inch wrench, remove jamnut (K) from shaft (F).
Go on to Sheet 2
TA252637
Change 1 6-15