TM 9-2350-222-34-1
SHIFTING BELLCRANK REPLACEMENT (Sheet 1 of 3)
TOOLS:
Slip joint pliers
9/16 in. socket with 1/2 in. drive
Torque wrench with 1/2 in. drive (0-175 lb-ft) (0-237 N.m)
Hammer
3/8 in. drive punch
Vise
SUPPLIES:
Cotter pin (MS24665-283)
PRELIMINARY PROCEDURE: Displace ammunition rack (TM 9-2350-222-20-1)
NOTE
Shifting bellcrank located on right side of driver's compartment, behind right ammo rack.
REMOVAL:
1. Using socket, remove screw (A) and screw (B).
2. Using pliers, remove cotter pin (C) from stud (D).
Throw pin (C) away.
3. Using socket, remove nut (E) from stud (D ).
4. Lift bellcrank (F) and three washers (G) from stud
(D).
Go on to Sheet 2
TA252631
Change 1 6-2