ENGINE ACCESSORY HARNESS ASSEMBLY REPLACEMENT (2D ENGINE) (Sheet 3 of 5)
10. Using 7/16 inch wrench, remove two screws (U)
11. Remove two clamps (W).
12. Using 7/16 inch wrench, remove screw (X),
lockwasher (Y), and flat washer (Z) from cover
13. Remove engine accessory harness from vehicle.
Place engine accessory wiring harness in position
From engine compartment, place cover (A) in
Using 7/16 inch wrench, install
lockwasher (C), and flat washer (D).
Place two clamps (E) in position.
Using 7/16 inch wrench, install two screws (F) and
Go on to Sheet 4