TM 9-2350-222-34-1
ENGINE ACCESSORY HARNESS ASSEMBLY REPLACEMENT (2D ENGINE) (Sheet 1 of 5)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Installation
TOOLS:
Spanner wrench
1-9/16 in. socket with 3/4 in. drive
7/16 in. combination box and open end wrench
2 in. socket with 3/4 in. drive
REFERENCE: TM 9-2350-222-20-1
PRELIMINARY PROCEDURE: Remove right fuel tank (page 4-36)
NOTE
Top two cables are disconnected to gain
access to the third harness which is the
accessory harness.
REMOVAL:
1. Using spanner wrench, disconnect three
cables (A) from bulkhead connectors.
2. Using 1-9/16 inch socket, disconnect jamnut
(B).
3. Using 2 inch socket, disconnect jamnuts (C).
4. Remove three cables (A) from bulkhead.
Go on to Sheet 2
Change 5 5-61