HULL-FRONT MASTER HARNESS ASSEMBLY REPLACEMENT (Sheet 16 of 21)
22. Connect connector (AM) to intermediate bilge pump
23. Connect two connectors (AP) to gas particulate
heater lead (AQ).
24. Install two clamps (AR) and screws and washers
(AS). Using socket, tighten screws.
25. Install two clamps (AT) and screws and washers
(AU). Using socket, tighten screws.
26. Install two clamps, screws, and washers (AV).
Using socket, tighten screws.
connectors (AW) and connect to purge pump
Go on to Sheet 17
Change 1 5-17