ACCELERATOR CONTROL LINKAGE ASSEMBLY REPAIR (Sheet 12 of 13)
20. Install new gasket (Z) into groove on bottom of riser
21. Slide tube assembly (N) through shaft (AA).
22. Place riser housing (S) with gasket (Z) onto control
housing assembly (B).
23. Using 1/2 inch wrench, install seven screws and
control housing assembly (B).
24. Aline tube assembly bearing (AC) within lever (AD).
25. Using 7/16 inch wrench, install screw (AE) to hold
tube assembly (N) to lever assembly (AF).
Go on to Sheet 13