TM 9-2350-222-34-1
FUEL PRIMER PUMP REPAIR (Sheet 6 of 6)
11. Place lever (Q) in vise.
12. Place operating handle (R) in position on lever
(Q).
13. Using 1-1/8 inch wrench, install nut (S) and
lockwasher (T).
14. Slide two connector shells (U) on two leads of
switch assembly (J).
15. Install two slotted washers (V) and slide
connector shells (U) down until seated.
16. Remove handle assembly from vise.
17. Place link (W) in position on primer pump (C).
18. Install pin (X) through link (W) and primer pump
(C).
19. Using pliers, install cotter pin (Y).
20. Place handle assembly (Z) in position on primer
pump (C).
21. Install two pins (AA).
22. Using pliers, install two cotter pins (AB).
23. Place clamp (AC) in position.
24. Using 7/16 inch wrench, install screw (AD).
TA130550
End of Task
4-91