FUEL PRIMER OUTLET FROM ENGINE TUBE ASSEMBLY REPLACEMENT (EARLY MODEL)
(Sheet 3 of 6)
7. Using 9/16 inch wrench and 11/16 inch wrench,
disconnect front outlet tube (R) from nipple (S) in
front of bulkhead (T).
8. Using two 11/16 inch wrenches, remove nut (U)
from nipple (S) and remove nipple (S) from rear
of bulkhead (T).
Inspect threaded components for thread damage. Replace or repair if defective.
1. Using two 11/16 inch wrenches, install nipple I A)
to rear of bulkhead (B) and secure with nut (C).
2. Using 9/16 inch wrench and 11/16 inch wrench,
install front outlet tube (D) to nipple (A).
Go on to Sheet 4
Change 1 4-76