36-56. ACCESS DOOR LATCH INSTALLATION PROCEDURE
TOOLS: 8 oz. ball peen hammer
3/16" drift pin punch
REFERENCES: TM 9-2350-222-10 for procedure to open and close cradle cover
EQUIPMENT LOCATION INFORMATION:
Driver's Master Control Panel
EQUIPMENT CONDITION: Driver's master control panel MASTER BATTERY switch set to OFF
Open cradle cover (TM-10).
Using hammer and punch, tap pin (1) toward periscope cover (2) until pin is through
one side of clevis (3).
Put one spacer (4) on pin (1). Put one end of spring (5) over spacer.
Put second spacer (4) inside spring (5).
Put latch (6) between opening in spring (5) so that spring tension is downward on latch.
Using hammer and punch, tap pin (1) through spacer (4) and latch (6) and other side
of clevis (3), until each end of pin is even with clevis.
Close cradle cover (TM-10)
END OF TASK