M219 MACHINE GUN MOUNT INSTALLATION
Using 3/4" wrench, put in two new self-locking bolts (1) and two flat washers (2) to
hold machine gun mount (3) to combination gun mount.
Using 3/4" wrench, put pivot screw (4) in upper part of machine gun mount (3).
On some tanks, self-locking nut (6) and setscrew (7) are
one piece. Allen wrench is not used.
Using 1/2" wrench and Allen wrench, tighten two nuts (5), two self-locking nuts (6),
and two setscrews (7).
Follow-on Maintenance Action Required:
Install 7.62-mm machine gun (TM-10).
Install empty cartridge bag (TM-10).
Install nylon ejection shield (TM-10).
END OF TASK
Pam 35-3 Cont