TM 9-2350-222-20-2-3-2
GUN SHIELD (MANTLET) COVER INSTALLATION PROCEDURE (CONT)
34-3.
FRAME 2
Procedure
Step
Using screwdriver. put on three clamps (1) holding gun shield cover (2) to xenon
1.
searchlight mounting brackets.
NOTE
If gun shield cover has two pleats, do step 2. If not, go
to step 3.
2.
Using hands. fold down two pleats (3) to make water-tight area when bellows is
clamped to gun.
Using screwdriver, put on clamp (4) holding gun shield cover (2) to gun tube.
3.
Place telescope cover (5) over port in gun shield cover (2). Using screwdriver, put on
4.
clamp (6) holding telescope cover to gun shield port.
Place 7.62-mm machine gun cover (7) over port in gun shield cover (2). Using
5.
screwdriver. put on clamp (8) holding machine gun cover to gun shield port.
Snap gun shield cover fasteners (9) holding cover to gun shield lifting eyes,
6.
7.
Manually elevate and depress gun (TM-10). Check that gun shield cover does not bind
through full range of gun elevation and depression.
NOTE
Follow-on Maintenance Action Required:
Install xenon searchlight and mounts (TM- 10).
Install 7.62-mm machine gun (TM-10).
END OF TASK
Para 34-3 Cont
34-8