LOADER'S SAFETY SWITCH ASSEMBLY AND GUARD INSTALLATION PROCEDURE
3/4 in. socket (1/2 in. drive)
7/16 in. open end wrench
JPG for procedure to connect electrical connectors
TM 9-2350-222-10 for procedure to do firing circuit test
EQUIPMENT LOCATION INFORMATION:
Driver's Master Control Panel
Driver's master control panel MASTER BATTERY switch set to OFF
Line up mounting holes in plate (1) and loader's guard (2) with mounting holes in gun mount (3).
Using socket, attach plate (1) and loader's guard (2) to gun mount (3) with three screws (4) and three
Connect three electrical connectors (6) (JPG).
Using wrench, attach ground strap (7) to gun mount (3) with screw (8), and two lockwaahers (9).
Follow-on Maintenance Action Required:
Test firing circuit (TM-10).
31.1-4 Change 1