TM 9-2350-222-20-1-5
GENERAL MAINTENANCE - Continued
Removal of Studs Broken at Surface
Using hammer, drive fluted extractor (G) into
9.
stud (B).
10. Manually start nut (H) counterclockwise
onto extractor (G).
11. Using wrench, tighten nut (H) onto extrac-
tor (G) by turning counterclockwise.
12. Using wrench, keep turning nut (H) counter-
clockwise until stud (B) is removed from
threaded hole (E).
13. Using clean rag, wipe out threaded hole (E) and
surface (F).
TA140831
C-13