TM 9-2350-222-20-1-5
INTERIOR RELEASE MECHANISM REPAIR (Sheet 6 of 1 1)
3.
If grommet (D) was removed, install new
grommet (D) into bracket (E).
NOTE
Before installing new grommet
into bracket, it will be necessary
to place grommet in boiling water,
using cooking stove, f o r 2-3
minutes. Using pliers and wearing
rubber gloves, quickly remove
grommet from boiling water and
snap it in place into bracket.
4.
Using hammer, install spring pin (F) into lever
(G).
5.
Position lever pin (H) partially into hole in left
side of bracket (E).
6.
Position thrust washer (J), lever (G), cam (K),
lever (L), and another thrust washer (J) onto
lever pin (H).
7.
Push lever pin (H) through right hole of bracket
(E) so that both ends of pin (H) are flush with
outside of bracket (E).
Go on to Sheet 7
TA140931
21-28