TM 9-2350-222-20-1-5
EXTERIOR RELEASE HANDLE MOUNTING BRACKET REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
Using hands, install new preformed packings
(A) onto bracket (B).
Using 1-1/8 inch wrench, screw nuts (C) all
the way down onto bracket (B).
Press bushings (D) and washers (E) into
couplings (F).
Using hands, push one end of tubes (G)
through washers (E) and bushings (D) until
ends of tubes (G) are flush with inside of
couplings (F).
Insert tubes (G) through holes in bracket (B)
bracket (B).
Be sure not to overtighten
collapse.
Using 1 inch wrench to hold coupling (F), use
6.
1-1/8 inch wrench and tighten nuts (C) against
coupling (F).
Place mounting bracket (B) onto vehicle.
7.
Screw two nuts (H) to mounting bracket (B).
8.
Using 1-1/8 inch wrench, tighten two nuts (H).
9.
Install exterior release handle control
10.
Install exterior release handle body assemblies
11.
End of Task
TA140916