PERSONNEL HEATER ASSEMBLY REPLACEMENT (Sheet 5 of 5)
Install coupling (K).
Close clamp coupler (L) and, using 7/16 inch wrench, tighten nut to secure exhaust pipe to heater
Using socket with torque wrench, tighten coupler (L) nut to 50 lb-in (6
Make sure all personnel heater connections,
especially exhaust pipe, are tight and secure.
Push quick-disconnect coupling (M) into fuel
hose line (N) to connect line to heater.
17. AIine pins of electrical connector (P) to holes.
18. Connect harness cable to connector.
19. Screw coupling (Q) over electrical connection.
20. Open fuel shutoff valve (page 7-346, step 12).
End of Task
All data on pages 19-24 thru 19-32 deleted.