RIGHT ANGLE DRIVE, CLUTCH, AND PUMP REPLACEMENT (Sheet 8 of 8)
Push electrical connector (V) on receptacle (W) and, using 7/8 inch wrench, tighten nut of
electrical connector (V).
Make sure packings have not fallen out of grooves of tube
assemblies (G) and (H).
Put new lockwashers and flat washers on eight screws (X).
Aline hose assembly (Y) with tube assembly (G) and, using 9/16 inch socket, install four screws
Aline hose assembly (Z) with tube assembly (H) and, using 9/16 inch socket, install four screws
Install transmission shroud (page 9-23).
Close engine compartment drain valve (TM 9-2350-222-10).
Remove container from under engine compartment drain valve.
Fill hydraulic reservoir (TM 9-2350-222-10).